you won’t believe it, but spray paint could truly be that simple.. That does not imply that you can just grab a tin of paint and go at it. There’re a couple of basics you require to recognize. Both in the preparation and application.

Step A: Prepare by gathering all of your items that you are going to require. Be sure your surrounding area is protected against whatsoever possible over spray. Whatsoever parts that dont require to be sprayed and that could be removed then do so. For other areas cover well with paper and masking tape.

Step B: You’ll have to examine the car cautiously for whatever rough spots. These’ll need to be sanded with three hundred grit sand paper. This’ll smooth out the rough spots. It also allows the spray car paint to adhere better. Once you have finished sanding, be certain every of the dust dirt and debris are gotten rid of from the vehicle. It is imperative that the car be absolutely clean.

Step C: You’ll need to apply a primer. This’ll make sure that you get an overall even coat of your coloured paint plus helps the paint to adhere well. When you spray the primer, make sure you apply light coats and allow for drying in ‘tween. How to spray car paint takes a little getting used to.

Step D: Now you’re pretty well to the point where youre about ready to spray the color. You will have decided to utilise the spray car paint that comes in aerosol cans, or perhaps you have opted for the spray gun. In either case, make a couple of practice strokes on an object before you begin with the car. Once youre ready, start the passes with the paint with out hesitation. If you hold the spray can or gun in one spot, you’ll end up with inconsistent coverage and perhaps the paint will run. If this occurs you’ve a big repair job on your hand. You’ll most likely have instructions as to how to spray car paint using the equipment or spray cans.

Step E: It is up to you whether you want to wet sand ‘tween coats of primer and color paints. You might want to research this selection on the web, or check with somebody that is familiar with how to spray car paint

Step F: Once youre entirely contented with the colour, you are down to the finishing touches. You will now want to apply several clear coats. This’ll give the gloss and completeed look to the car as well as protect the finish. Likely 2 coats will be enough but it’ll be up to you. Make very sure it is dry in ‘tween coats.

Step G: Once again, you’ve the selection of wet sanding if you choose. Over again, I suggest you ask the advice of people that’re familiar with how to spray paint a car. Say you decide to follow this step then you require to wet sand with the following grits in this order. Utilize eight hundred, one thousand, one thousand two hundred, 1500 and finally the two thousand. This’ll take out spots that might be overly heavy in the clear coat application.

Step H: Now you will want to utilizing a rubbing compound to buff the surface so you could use a 2000 grit to get rid of whatsoever scratches.

Step I: You should now buff the surface. To do this just utilize a moderate cut polish. Once you have done this, you should have a perfect glassy look to the finish.

Step J: Ultimately, you may want to apply a couple of coats of wax.

No Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URL

Leave a comment